Drum Stirring of Chemical Raw Material / Lubricating Oil Additives where sedimentation occurs due to specific gravity variation of
ingredients is a difficult task. The limitation being the drum bung opening. The universal drum opening is 54 MM for MS Drum where
it is 44 MM for HDPE Plastic Drum.
The propeller diameter of conventional stirrers are too big to be inserted through a bung opening which forces the user to opt for
either manual stirring or cut open the barrel to enable the conventional stirrer to be inserted, which makes it cumbersome and time consuming.
IDM Drum Stirrers, a light, portable and continuous duty rated allows quick blending without removing the drum lid. The Drum Stirrer Assembly
incorporates a threaded stainless steel nipple to allow mounting on the opening of drums.
Our unique bridge design with foldable propeller with detachable drive motor allows for simple drum stirring.
Lid mounting with large folding propellers and heavy duty drives are combined to provide uniform blending. No "dead spots" or settled out material
is ensured regardless of viscosity or solid content.
Models are also available with fixed blades to handle light water-like solutions to liquids with viscosities up to 12,000 cps.
All models are powered by either Continuous Duty Electrical AC Motors or Heavy Duty Air Motors.
Electric 440 V/ 3 Phase / TEFC or Industrial Service Air Motors
1440 RPM (Nominal)
¾ " Diameter x 32" Long
All wetted components are SS 316
2" BSP SS Nipple
4” ( Open )
5 Meter Line Cord with ON – OFF switch for 3 Phase Motors.
5 Meter Line Cord with Toggle switch for Single Phase Motors.
Explosion Proof, 50 HZ, with ON-OFF Push Button.
Available Air Lubrication Set with Air Filter, Regulator, Lubricator for Air Driven Models